Verifying the a/c installation

Share your modification plans and experience!
Post Reply
User avatar
ARPE
Posts: 45
Joined: Mon Feb 20, 2017 7:02 pm
Location: Miami Beach, FL

Verifying the a/c installation

Post by ARPE » Tue Feb 20, 2018 8:04 pm

I got my Bavaria R40 and started getting to know the boat. The first thing I noticed is that the boat has four a/c units (2 of 8K BTU and 2 of 12K BTU). The two small size ones serve a berth plus a head each, the two larger ones serve the galley area. Although 24K BTU seems a good size at first glance, I am not sure it is properly sized for summer in South Florida.

I decided to review the installation to ensure the air flow distribution is optimized to take the most of the a/c units. The return air inlets seems sized to minimum limit and the supply air seems undersized (when compared with Dometic recommended sizing shown in the table below). I am posting this “kick-off” here and will be posting my conclusion as reply to this post.

The table attached may be useful to you as it covers other a/c sizes, I took it from the Dometic installation manual
46D1EC32-0545-4434-9982-7C56C1118213.jpeg
You do not have the required permissions to view the files attached to this post.
2018 Bavaria R40 Coupe, D6-370
2015 Regal 35 Sport Coupe, D3-220 - Sold

User avatar
ARPE
Posts: 45
Joined: Mon Feb 20, 2017 7:02 pm
Location: Miami Beach, FL

R40 Cabin a/c located under co-pilot seat

Post by ARPE » Wed Feb 21, 2018 5:07 pm

The unit is installed under the co-pilot seat and serves a single grill, located in the top cabinet near the back door. By inspection I found the following:

1) Air return
The return grills have filters and the a/c unit has a filter. Besides the two return grills, there is also a disguised return without any filter (in the picture I am pointing to the disguised return).
image1-1.jpeg
My first step was to remove the return grill filters. The picture shows the filters, it is simpler to remove from the interior side.
image2-1.jpeg
The return area is 2 times 4.25" x 11" (two return grills) plus 28" x 1" (disguised return), this gives us and area of 121 sq in. Dometic requires 130 sq in, hence this is adequate given that there are other not accounted for small air intake holes.

2) Air supply
A 6" isolated pipe runs straight behind the cabinets and then up to the upper cabinet supply grill. There are three 90 degrees curves (at a/c exit, horizontal2vertical, vertical to grill area).

Bavaria installed a return grill with filter instead of t a proper supply grill. My short term correction was to remove the filter, but I will replace return grill by a proper supply grill to be able to change the air flow direction.
image1-2.jpeg
The supply area is 4.2" x 11", which is 46 sq in, Dometic recommends 70 sq in. I am investigating if the pipe should be split to serve a disguised supply opening of 3.2" x 4", which is 12 sq in. This would bring us to 58 sq in, which is closer to Dometic recommendation.
image2-2.jpeg
I can already see major air flow improvement after the removal of the three filters, we still have the potential for further airflow improvement with the splitter. Another pending improvement is the replacement of the return grill used by a supply grill as it will allow diverting the air flow to the ceiling when desired.
You do not have the required permissions to view the files attached to this post.
2018 Bavaria R40 Coupe, D6-370
2015 Regal 35 Sport Coupe, D3-220 - Sold

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest